Installation

We install! Contact us for rates.
All parts and installation are covered by 1 year warranty.

SPECIFICATIONS FOR SAUNA CONTRACTOR OTHER THAN SPRINGS SAUNA COMPANY

Walls and ceiling shall be 1"x4" select, certified, kiln-dried (moisture content not exceeding 11%) T&G, v-joint, clear 1"x4" vertical grain Redwood, clear 1"x4" Western Red Cedar, clear 1"x4" Alaskan Yellow Cedar, or clear 1"x4" V.G. Western Hemlock. All boards shall be blind nailed with 5p galvanized, hot dipped nails, or power stapled with galvanized staples (Highly recommended).

The following specs shall include and match one of the four woods listed above:

Benches shall be clear S4S kiln-dried 2"x2" tops with 1/2" spacing and 2"x4" facing; glued and fastened with exposed nails countersunk. bench tops shall be fastened from bottom to eliminate exposed metal.
Door shall be FGD 2'0"x6'8" of vertical grain Doug Fir rails and clear hermetically sealed, double glass, tempered (16"x60") with casing, jamb, and threshold of Redwood.
Door hardware shall be (3) 4"x4" butt hinges, Ives ball catch MP347B3, (2) wooden pulls
Vent shall be (2) 4"x10" louvered V10 for upper wall placement and lower wall placement. RO 3-3/4"x9-3/4"
Removable flooring shall be Super Dek interlocking 12" squares - sanitary, non-skid surface in terra cotta color - over walking area of base floor
Light shall be wall mounted, vapor proof Progress P5511, satin finish cast aluminum, rated for 75 watts
Sauna heater shall be HARVIA/FINLANDIA model ... as per cubic footage and voltage requirements
Heater fence shall be of 2"x2" & 1"x2" and shall be places 2-1/2" away from the Sauna heater
Temperature controls/Contactor
Accessories listed in accessory section of the site
Stones shall be peridotite, heat testes, igneous type from Finland
Precut and Prefab Saunas shall be as per specifications on FPC and FPF pages

Warranty shall be 1yr. on room materials and workmanship, and a 1 yr. warranty on Sauna heaters when installed according to Finlandia specifications and wiring information.

Specs for Contractors

general contractor | electrical contractor | other contractors

GENERAL CONTRACTOR SPECIFICATIONS

Framing of walls and ceiling shall be of dry Doug Fir, construction grade no. 1 or 2, 16" o/c. use pressure treated plates against concrete.

Ceiling shall be 7'-0" from finished floor to ceiling joists (16" o/c)

Door shall be roughed in at 26" x 82" and must open out

Insulation of walls and ceiling shall be of min. R-11 (pref. foil faced) fiberglass batts

Drywall shall be 5/8" Type-X (Only if req'd by local building code - Req's also additional furring strips over drywall)

Added Vapor Barrier shall be Type-C construction foil over insulation or drywall -- walls and ceiling

Flooring shall be of hard surfaced, waterproof type -- concrete, ceramic tile, heavy duty seamless vinyl

Floor drain is recommended for new construction and is essential for commercial and public Saunas

Exterior walls shall be of drywall, paneling, etc. and exterior painting, door finishing, etc. shall be included

ELECTRICAL CONTRACTOR SPECIFICATIONS
(Must be licensed and bonded)

Rough-in for Sauna controls, heater, room light shall be as per wiring diagram (provided with control box or in heater box / supplied by Springs Sauna Company on case by case bases)

Hookup of controls, heater, and light shall be as per Finlandia wiring diagram. COPPER WIRE ONLY